How to properly use a spray 1. Prepare 1.1 before driving. Pipe joints sealing material is installed, and then connect it to promise not to let unheated air into the drying chamber. 1.2. Check static equipment, piping, static sealing point, whether the high-speed centrifugal spray run, run, drip, leak and blockage. 1.3. Doors and observation aperture is closed, and check for leaks. 1.4. Check the electrical linking high-speed centrifugal spray lock, meters, valves, etc. are normal. Tighten pollinator barrel bottom and the bottom of the cyclone, it requires pollination must be clean and dry. Check the seals before installation is off, did not fall off before then tighten pollinator. 1.5 Jog start centrifugal fan start button, check the direction of rotation centrifugal fan run correctly. 1.6. Come to the atomizer motor mouth oiling to observe more than half hole, after opening the oil circulation pump. 1.7. Adjusting check valve at the outlet of the centrifugal fan is turned on. (Note: Do not shut the valve, otherwise it will damage the electric heater and air intake duct, it must be given sufficient attention) 1.8 feed connecting pipe pump is connected, the rotation direction of the motor and the pump are correct. 1.9 The top of the drying chamber mounted spray head is covered, so as not to leak. 1.10 Close the feed outlet of the pump. 1.11. Check the feed pump is normal. (According to the rules centrifugal operation, inspection) spray long-running or improper operation will appear in the part of the spray granulation dryer aggregate affect the normal operation, a spray dryer, then the need to stop work cleaning, drying tower aggregate for clean-up, clean the door should open, high-performance spray dryer with a long broom to sweep the bottom of the funnel-shaped aggregates, open the outlet valve, open the freezer, you must open circulating water, Boiling tap water granulating dryer tower. After running around 600h, the need for a spray dryer into the boiling granulating line necessary inspection and maintenance. For the feeding system, spray dryer vibration, should check the filter, pipes, valves, nozzles, etc., to see whether the blockage, low noise and a spray dryer, regular cleaning, inspection boiling granulating dryer nozzle wear so and Replace boiling granulating dryer. After running around 600h, check the feed pump oil leaks, pressure is normal, the oil level is normal and so on. Boiling dryer system fan, you should check whether the shaft and bearing short of oil fever, with or without vibration, noise, etc., if necessary, clean the tubing, pump, nozzle three of the filter. Spray Dryer and positive _ _ spray dryer drying process by Changzhou City Drying Equipment Co., Ltd. and positive. Spray Dryer and positive _ _ spray dryer drying process is positive, Changzhou and Drying Equipment Co. (www.hzdrying.com) this year introduced a new upgrade, the above picture is for reference only, please call the contact or pictures on this page phone, for the latest information, contact: Gary.